中文 » English » Browse By Category » Cell and Tissue » Ussing System » Ussing System - Large Reservoir, Large Rectangular Chamber
Ussing System - Large Reservoir, Large Rectangular Chamber
|
- Direct connect low-resistance electrodes
- Simple operation, easy to control temperature and clean after use
- Luer type leak-free attachment of tubing and electrodes
- Recessed electrode ports avoid bubble formation
- Accommodates tubular tissues from small animals
|
| Description |
Includes:
Large rectangular chamber (CHM7), stand, reservoir, electrodes, and tubing
Ussing Chambers
WPI’s classical Ussing Chambers are well established perfusion chambers that are easy to operate, easy to control temperature, and easy to clean after use. Hundreds of them are used daily by scientists in the field. Ussing Chambers are machined from solid acrylic with eight entry ports for fluid lines, electrodes, or agar bridges. For easy, leak-free attachment of tubing and electrodes, all eight ports are luer type. The four ports for voltage and current electrodes are recessed to prevent formation of air bubbles in the chamber. The fluid compartments in each side of the chamber are separated by the epithelial membrane being studied. Sharp stainless steel pins on one side of the chamber hold the membrane in position and mate with holes in the opposite chamber interface. (In the CHM4, tissue is held by an O-ring instead of pins.). The CHM5 chamber adapts the Costar Snapwell, a cell culture insert for monolayer cell culture, into WPI’s “classical” epithelial voltage clamp system. Until now, classical Ussing Chambers have not been widely used for monolayer cell culture inserts because most inserts have a very deep profile, limiting good fluid perfusion at the surface of the membrane - and limiting voltage electrodes from measuring the potential close to the surface of the membrane. CHM5 solves these problems: Perfusion fluid is introduced into the chamber at an angle so that it will flow directly to the surface of the membrane. The voltage electrode is also inserted into the chamber at an angle so as to reduce the distance between the surface of the membrane and the electrode. Drains may be added to Ussing chambers to allow quick and complete evacuation of radioactive or toxic substances.
Cartridge Electrodes
The Electrode Kit contains four voltage/current electrodes, plus four luer-tipped cartridges. Electrodes are threaded and screw securely into the end of each cartridge. The luer tip then plugs securely into the luer openings of the chamber. The cable from each electrode terminates with a 2 mm pin which may be plugged into voltage/current clamps such as WPI’s SYS-DVC1000 or SYS-EVC4000. The miniature electrode-gel cartridge is a small plastic tube with a male luer tip identical to those at the tip of hypodermic syringes. The tube may be filled with different gel materials; agar is commonly used but other gel materials may also be satisfactory.
Circulation Reservoirs
Hand-blown borosilicate glass, with jacketed chambers for temperature control. Available in two sizes - #5210 holds 20 mL per side, and #5362 holds 10mL per side (useful when expensive chemicals are involved). Reservoir condenser caps prevent air bubbles and turbulence in fluid reservoirs.
Water Bath
The Haake DC10-P5/U Constant Temperature Water Bath has been tested at WPI and found to be ideal for WPI’s Ussing system. It can provide simultaneous warming for up to 16 systems. Menu-driven control module allows easy temperature setting, correction and display, with temperature accuracy of ± 0.02°C. |
| Specifications |
Additional information not available |
| Manuals and Resources |
Instruction Manual
Ussing-IM-040302.pdf |
| References |
Have you seen a reference to this product in a published paper? If so, email your contact information and the citation and we will send you a free gift! |
| Ordering Information |
To place an order for this product, please contact the appropriate WPI office or distributor.
Customers can order direct from our China office:
WPI China
Address: Rm.20A, No.8 Dong Fang Rd, Liang Feng Building, Lu Jia Zui Financial District, Shanghai PRC
Phone:+86 21 68885517
Fax:+86 21 68885537
Code:200120
|
| Accessories |
There are no accessories for this product. |
| Application Notes |
Application Notes
No Application Notes available for this product at this time. |
|
©Copyright 2008 World Precision Instruments, Inc. All Rights Reserved.
