WPI Inc | UltraMicroPump

Browe By Category

Main Menu

中文 » English » Browse By Category » Pumps and Microinjection » Microsyringe Pumps » UltraMicroPump

UltraMicroPump

* Versatile injector uses microsyringes to deliver picoliter volumes
* Syringes are easily installed, just snap the barrel into the clamps
* Threaded shaft drives syringe plunger allowing smooth and accurate movement
* Accepts syringe diameters 5.5 - 9 mm
* Single pump without controller

Description	Picoliter volumes With its digital controller, UltraMicroPump III can dispense as little as 600 picoliters per incremental advance of the syringe piston (using a 5uL syringe). Syringes may be filled externally and then inserted into the pump or filled while mounted in the pump. Fluids injected or withdrawn are held entirely within the micro syringe to maintain a low fluid dead volume. Positioning For positioning, the UltraMicroPump III may be attached to any of several WPI micropositioners such as the M3301 (manual), DC3001 (motorized), or any manual stereotaxic manipulator. Smart Controller An Integral component in the UMPIII system is a microprocessor-based controller, SYS-MICRO4, which provides an "intelligent" and easy-to-use interface to up to four syringe pumps. Operating parameters are set with the membrane keypad and LCD display. From the keypad the user can select the following functions: set pump to infusion or withdrawal mode, enter the volume to be infused or withdrawn, rate of delivery, and syringe type as well as synchronize the starting and stopping of any combination of syringe pumps. User parameters can be stored in the device's "non-volatile" memory for instant recall when the unit is powered on. An optional footswitch can be plugged into a connector on the rear of the controller for "hands free" start/stop operation. Computer Control - An RS-232 port on the rear of the controller can be used to connect it to a computer for use with computer control programs.
Specifications	Additional information not available
Manuals and Resources	Instruction Manual ump3-im-032708.pdf
References	Have you seen a reference to this product in a published paper? If so, email your contact information and the citation and we will send you a free gift!
Ordering Information	To place an order for this product, please contact the appropriate WPI office or distributor. Customers can order direct from our China office: WPI China Address: Rm.20A, No.8 Dong Fang Rd, Liang Feng Building, Lu Jia Zui Financial District, Shanghai PRC Phone:+86 21 68885517 Fax:+86 21 68885537 Code:200120
Accessories	15867 - Footswitch for SYS-Micro4 Controller 40500 - RS232 Cable, 9-pin D connector 502201 - V-clamp for UMP3 SYS-MICRO4 - Four channel micro controller
Application Notes	Application Notes No Application Notes available for this product at this time.